dling
11-23-2008, 09:39 AM
I have a big problem. While replacing the convergence chip I kept the soldering iron on to long and the solder tab raised up off the board. :(
Is it possible to replace the whole board?
Thanks
David
lcaillo
11-23-2008, 09:38 PM
No need to. Just scrape back a bit on the trace and either bend the pin over to make contact, and solder it down, or bridge the gap with a small bit of wire.
dling
11-24-2008, 05:06 AM
Just curious, do you know what the area looks like that I am referring to?
This area has a lot of pin hole in a row that the convergence chip plugs into,they are very close together.
I will look at that when I get home today. I hope you are right.
Thanks.
