View Full Version : PT-47WX42F stock convergance values
kazkillinger
03-21-2009, 09:37 PM
Hey guys i bought a sammy PT-47WX42F that had the blue color out of lined. i purchased the service manual thinking it would have all the stock convergance values but it doesent. Can anyone give me there current convegance values thanks!
lcaillo
03-23-2009, 06:56 PM
There are no stock values. Each set is individually aligned. YOu cannot expect to align your set by using the values from another. It might get you in the ballpark if you changed a board, but then again, it might not.
I don't know how I missed this post, but you probably have blown convergence ICs. See the following post on the topic. You should also replace any resistors on the circuit and check for cracked solder. Read post 1 of the following thread carefully and thoroughly, along with the links there.
http://www.hdtvoice.com/voice/showthread.php?t=28929
I assume you meant Panny, not Sammy.
kazkillinger
03-27-2009, 08:55 PM
yeah i did the convergance sorry should of stated that earlier. i was just hoping to have a start off point for the convergance. The guy who i bought this from screwed it up horribly.
