 |
| |||||||||||||
10-30-2002, 07:10 AM
|
#1 |
|
HDTVoice Member
Join Date: Sep 2002
Location: Pa
Posts: 48
|
Mits SR-HD% Help
I have a Mit STB that I use for OTA for my Digital Local channels. I was receiving all 6 channels and then all of the sudden nothing. I check the signal strength in the Set up menu and they are all reading over 80 like before. I goto to my local channel area setup and it only shows the analog stations as being available no digital. I cleared the list reset my zip and did a find local channels again. But still no Digital just analog channels.
Is the Receiver Faulty or what. Any help would be appreciated. I also brought my other mits STB down and hooked up and the Digital channels are there and displaying no problem!! |
|
|
|
11-01-2002, 07:00 PM
|
#2 |
|
HDTVoice Member
Join Date: Nov 2002
Posts: 1
|
I'm having a similar problem. When I disable the Satellite Dish
from the setup menu (i.e. 'No Dish attached'), the OTA digital channels come in OK after doing a 'scan' for local channels. When I reenable the dish antenna, the firmware starts 'UPGRADING PROGRAM MENU...' When this is completed, the digital channels no longer show up as available, although they are present by doing a signal strength test. I am able to trick the box by repeating what I have indicated and while the unit is 'UPGRADING PROGRAM MENU...' I press the exit button. Simply sounds like a firmware bug.. Any other suggestions?? Jim |
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
Linear Mode
|
|
All times are GMT -5. The time now is 05:11 AM.